Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. warden_clyffe

    MSC. Software: ADAMS CAR

    Hi Alex, I am a senior university student, graduating in 3 months. I can use Adams car, Adams View and Adams Insight. I follow you on Linkedin and I have shared some of my work there. My name is Sefa Temur. Can you help me with job opportunities?
  2. warden_clyffe

    MSC. Software: ADAMS CAR

    Hi Alex, I just use same double wishbone template for front and rear suspension system. but i used fixed joint for rear tierod. I have 3 years experience from Adams View but now I'm working particularly full vehicle tutorials in Adams Car. Thanks for answer.
  3. warden_clyffe

    MSC. Software: ADAMS CAR

    Hi everyone, I am trying to learning a while Adams Car. I read and done a lot of training pdf's but i can't figure out how i can deactivate a shaft from double wishbone suspension system in template builder. Should i deactivate general part or construction frame or what? Yes there is double...
  4. warden_clyffe

    MSC ADAMS VIEW

    Thank you for your help. Have a good day.
  5. warden_clyffe

    MSC ADAMS VIEW

    But there is a default contact with tire and road. Just /Car don't show this us. Isn't it? Thanks for your answers.
  6. warden_clyffe

    MSC ADAMS VIEW

    I used /Car and made same model and it is too simple. You are right, but i am trying make a full car in Adams View. And when i compare some results Adams Car and Adams View model, these results almost same. I try to figure out which parameter or parameters made failed analysis. Because in low...
  7. warden_clyffe

    MSC ADAMS VIEW

    I designed a full car in 1 year. It has 122 DOF, hundreds of contact, 134 moving parts and 147 joint. System is working but in some different velocities and road types model stopped a little bit after. Each of my analysis takes about 6, 7 hours for 45 second analysis. So i tried too much values...
  8. warden_clyffe

    MSC ADAMS VIEW

    Hi everyone, I can't understand contact forces in Adams View. How can i decide value of stiffness, force exponent, damping, penetration depth, stiction velocity and friction velocity? Is there a any equation about this terms?

Part and Inventory Search

Back
Top