Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. cebain

    Orifice Plate-Water

    Thanks all. I ran through the calculations in ISO 5167-2. Pretty involved stuff, but I found that if I set the flow rate to design condition of 300 gpm and solved for the Reynolds number (this would give me the design conditions Reynolds number), and then plug the Reynolds number into the...
  2. cebain

    Orifice Plate-Water

    Thanks to both of you. I'm going to download a copy of ISO-5167. What is the difference between ISO 5167-1 and ISO 5167-2? Both seem to refer to orifice plates.
  3. cebain

    Orifice Plate-Water

    Hi all. I need a white paper showing some calculations for sizing an orifice plate with flange taps. Round bore, through hole (no taper). My application is as follows: 10" ID pipe, 200 inH20 pressure drop. 80 psia line pressure. 300 gpm flow rate. Flange taps (1" up and down stream)...

Part and Inventory Search

Back
Top