Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. dandy408

    Strongest material heat treated or non-heat treated

    I am going to make some shafts to mount the rod end of a hydraulic cylinder to. The shaft (red) will only be .75" diameter and increasing in diameter to 1 1/2 with generous radii. I will then light press into the large shaft (pink) and retain with a roll or taper pin, crossdrilled in the pink...
  2. dandy408

    Hole asterisk not showing up, cannot change hole location

    Solved...! I had changed the Pixel Culling in both static and dynamic to greater than 0. I changed back to 0 and solved the issue.
  3. dandy408

    Hole asterisk not showing up, cannot change hole location

    I create a hole and try to dimension the center point of the hole and there is no point or asterisk. I can dimension by the origin, which I never do, but then the dimension lines are brown instead of green. When I double click on the dimension and change the value, the value will change, but...
  4. dandy408

    Need opinions and wisdom on new computer with R19

    First time to this forum.... Currently running V5R18 on a Dell 670 with XP 32 bit. My new computer is arriving in 3 days and will have Win 7 64 bit, Intel i7 X980 3.33GHz, 12Gb mem, Quadro FX1800, 1Tb HD, may spring for a Solid State Drive also shortly. Besides designing assemblies which...

Part and Inventory Search

Back
Top