Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. alionoa1

    Axis Creation ?

    Thanks Adrian...really have not used those much but know I know.
  2. alionoa1

    Axis Creation ?

    Hello All, I want to create an axis that finds the intersection of the center of 2 symetric holes located on 2 symetric compound surfaces or planes. It would be as if you were placing a shaft thru two holes that are at the same height, but angle away and up from each other equally. I'm getting...
  3. alionoa1

    Sketching Section View-Best Practice?

    Hello Again, Just wondering if this is the best way to do this? I have attached a screenshot...I created a section though a plane, then a datum curve, and will sketch around the datum curve(blue line) using the section datum as plane to sketch on. The only issues I have are the process of...
  4. alionoa1

    Create component in Assem Mode

    One more question-what if I want to sketch a outline of a compound contour on a datum plane slicing thru the assembly? An example would be if you wanted to make 1/8" plates every half-inch to cradle an apple. Say the plate is 2.00 x 0.12 x 6.00 so that what would remain is the plate(s), less the...
  5. alionoa1

    Create component in Assem Mode

    Let me think out load on this...I have been creating my own subassembly for my fixtures(w/parts & subs underneath) and the parts I am modeling around are on thier own sub assembly above my assembly. I do use edges and surfaces from the provided model to create my geometry...but then I have no...
  6. alionoa1

    Create component in Assem Mode

    These were good suggestions which I will use but I can't help but wonder...I use Pro_e for Tool Design which means I am modeling around forestry equipment assemblies and weldments(WF3). This means when I am finished, I really should not have any mates or relations to the the assem/weldments I am...
  7. alionoa1

    Create component in Assem Mode

    Hello, When you create a component in Assem-mode...there are no drawing views created (front,right,etc.)nor are there any parameters driven to the drawing.(part name, material, etc.) How can I resolve this? I have been getting up to Speed on Pro_e for the last 5 weeks and it has been a couple...

Part and Inventory Search

Back
Top