Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
auotmatic page numeration and conclusion of rsults
Hi, just 2 little questions: I made a calculation.. about 35 pages ;-) Now I have to print it. Is it possible to print it with page-numbers, so that I can make a short overview where to find e.g. shaft diameter and so on? Or does Mathcad make a list of content too? And the second question...- sunrise70
- Thread
- Replies: 1
- Forum: PTC: Mathcad
-
helix angle
Hi, I'm a new autocad user and a few days ago I should draw a pinion shaft. So I made a hand layout and all the calculations. Finally I wanted to draw my shaft in autocad. With the shaft-generator. So far so good. Everything's fine but there was a problem drawing my pinion shaft because it's a...- sunrise70
- Thread
- Replies: 0
- Forum: Gear and Pulley engineering
