Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Search results for query: *
- Users: falcon14110
- Order by date
-
Fast Air Pump Advice
As I said the entire system is enclosed. when the piston is at top dead center the system is pressurized to 6psi. Before the At bottom dead center the system will be at .25psi. Before the system starts the piston is brought to bottom dead center and pre-charged to the .25psi. The system will be...- falcon14110
- Post #3
- Forum: Gas compression engineering
-
Fast Air Pump Advice
I'm in need of a way to seal a pneumatic piston. The piston needs a bore ID over 7.5 inches with a stroke between 2 to 3 inches. The piston will stroke an entire cycle in 400ms. The pressure within the cylinder will not exceed 6psi. The volume of air which the piston will move is enclosed so I...- falcon14110
- Thread
- Replies: 3
- Forum: Gas compression engineering
