Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. I-DEAS

    Comparison of FMEA standards IEC 60812 and MIL-STD-1629A.

    Thanks IRstuff - yes my typo, now corrected.
  2. I-DEAS

    Comparison of FMEA standards IEC 60812 and MIL-STD-1629A.

    Hi, I'm considering comparing some FMEA standards, specifically IEC 60812 and MIL-STD-1629A. But perhaps someone has already done this? If so, are you interested in sharing? Many thanks.
  3. I-DEAS

    Comparison of FMEA standards IEC 60812 and MIL-STD-1629A.

    Hi, I'm considering comparing some FMEA standards, specifically IEC 60812 and MIL-STD-1629A. But perhaps someone has already done this? If so, are you interested in sharing? Many thanks.
  4. I-DEAS

    AGMA rating of a rack and spur gear

    Hi All, When assessing spur gears using AGMA (say 2001-D04), many of the equations require that both the pinion and gear are both spur gears. The most simple case is u = gear ratio. What should one use when the gear is a "rack" (and therefore such equations aren't appropriate)? Many thanks...
  5. I-DEAS

    Identify results on multiple viewports - NX Simcenter

    I have solved this issue by using the nearby 'Annotation' icon instead of 'Identify Results'. The annotations remain, when moving between viewports.
  6. I-DEAS

    NX I-deas 6.5 - Access denied

    To prevent 'access denied' and/or having to 'run as administrator' in Windows, you need to change the directory that I-DEAS will start from. Please try the following: 1. Using Windows File Explorer, make a directory that you have full access to (e.g. read/write access). Perhaps...
  7. I-DEAS

    Identify results on multiple viewports - NX Simcenter

    Hi All, In NX Simcenter, when post-processing results, I have 2 viewports open (side by side). I have slightly different results in each viewport for the same part in order to compare. I have then used the 'Identify Results' icon to select the individual nodal stress at a given node (see...

Part and Inventory Search

Back
Top