Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. itsdark

    Concact surface length piston and cylinder in Ansys

    Anyone any idea, or know if this can even be done?
  2. itsdark

    Concact surface length piston and cylinder in Ansys

    Hi everyone, I am quite new to the world of ANSYS APDL and FEA so don't have much experience. I am trying to conduct a contact analysis of a polumer coated piston pushed against a cylinder wall. I have created a simple 2-D model and obtained a solution which is giving me values for contact...
  3. itsdark

    Ansys Maximum shear stress and adjusting colour scales

    Hi everyone, I am a novice where it comes to ansys workbench and am still learning the basics so this might seem like two daft questions but I could really be doing with some assistance. Firstly. What is the maximum shear stress showing when you plot it in workbench? I mean I understand what...
  4. itsdark

    Shear stress in a tapered (non-prismatic) beam

    Thanks for you help. Im still struggling to get my head around this, what I have is a beam with a uniform pressure applied over it so I'm not sure in this situation if the bending force and perpandicular component of the shear force would also have to be taken into account. To be honest I really...
  5. itsdark

    Shear stress in a tapered (non-prismatic) beam

    Hi everyone I am trying to determine the shear stress in a non prismatic beam and was wondering if anyone knew a good place to source some formula or better yet even had some worked examples. Any help would be very much appreciated I have been stuck with this for a few days now.
  6. itsdark

    Shear stress on a curved surface

    Hi everyone, I am trying to find an analytical approach to determine the shear stress induced on a curved surface. I had originally applied simple shear theory for beams but the shear stress distribution will not be uniform for a curved surface. More specifically I am trying to work out the...
  7. itsdark

    Splined Shaft in solidworks

    Thank you mfgenggear for your help, I think I have now managed to successfully create a solidworks model which I think looks fairly reasonable, I used some geometry and calculations from the machinery handbook so fingers crossed its accurate.
  8. itsdark

    Splined Shaft in solidworks

    Cheers guys for all your help, I've gone throught the calcs in the Machienery handbook and have drafted up two models, one for each of the shaft variations. I am having issues determaning how much to fillet the edges at the top and the bottom of the teeth, the spline is a flat root slide type...
  9. itsdark

    Splined Shaft in solidworks

    Thank you for your help. Is there an easy way to make them in solidworks without any specialised software?
  10. itsdark

    Splined Shaft in solidworks

    Hi everyone, I am trying to create a solidworks model of an involute splined shaft, in particular the male externally splined shaft. I was wondering if anyone has any idea how to create an accurate model. I found articles reffering to software called SplineGen but have been unable to find the...

Part and Inventory Search

Back
Top