Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. geodan

    CPT pwp dissapation rate test

    I posted this in Foundation Engineering, but I'll ask here also. During CPT testing on a current project, the cone was stopped and the pore water pressure was allowed to drop. This was done for several intervals within the clay layer (prone to settlement) in question. Results were given on a...
  2. geodan

    CPT pwp dissapation rate

    During CPT testing on a current project, the cone was stopped and the pore water pressure was allowed to drop. This was done for several intervals within the clay layer (prone to settlement) in question. Results were given on a plot with pwp on the y axis and time on the x axis. The resulting...
  3. geodan

    P.E SEAL a question of ethics

    ditto zcp. From the initial description, the engineer is clearly in the wrong. However, it would be prudent to ascertain all the facts and evidence before going forward or making any absolute dununciations.
  4. geodan

    On SOIL dilation angle

    Might I ask what you need the 'soil dilation angle' for?
  5. geodan

    Temporary slope stability - Excavation

    Gasp. This is a mind boggling thread. I agree with BigH 110%!! If you want to do it as a learning exercise, by all means do it... but for a real project where PUBLIC health and safety is at risk???!!? I think it is a breach of professional ethics for someone inexperienced in soils to design...
  6. geodan

    Driven concrete filled pipe piles

    gman11 is correct in that filling the pile will not increase the tip capacity. Do you have soil borings and subsurface soil information? Soil type, strenght, properties? Are you looking at an end-bearing pile? Deep foundations can get very complicated. Different types of piers also have...
  7. geodan

    Shallow Pier Foundations

    I would use end bearing only. Skin friction increases with depth and as such, there is very little friction in the top 5 to 10 feet. Also as they are not (I assume) driven piles, the increase in soil stress along the pier would be minimal. I would neglect skin friction for 4 to 6 foot deep...
  8. geodan

    Residential found. wall design with extreme lateral load

    Before you go through all that work designing the wall, I would seriously look at the recommended equivalent fluid pressure of 81 psf! This.. IS an awfully high equivalent fluid pressure! I would ask what soil values he used to determine this? Because you are dealing with a basement wall and...
  9. geodan

    Pavement debris as engineering fill

    We have allowed crushed/pulverized pavement-concrete materials to be used in a variety of structural fills. Depending on the post-develpment use, we have specified different gradiations or a different maximum particle size. In general, for light loads (shallow foundations and parking areas) we...
  10. geodan

    Slope stability with vegetation

    Everything has been pretty well covered here, however I would also add that in general the potential for slope instability increases with added mass. Hence, if vegetation is able to reduce the amount of water infiltration (increase of mass and decrease of strength) through absorbtion or runoff...
  11. geodan

    Why 95% Compaction

    Yes I agree Big H, I was just being a bit facetious. As a company policy we have required our techs to record the void ratio (when using the nuclear gauge for fill QA/QC testing) for each test taken as it helps me to review their work. However the void ratio varys greatly with the material...
  12. geodan

    Why 95% Compaction

    BigH :) Good lord if you wish to monitor void ratio during fill placement (most moisture-density gauges) then you must come up with AASHTO method of determining the required void ratio for each individual soil type... ahhh! incidently in sw washington, for sandy silt/silty sand: 100% of the...
  13. geodan

    Continual water running thru sump pump.

    tim In theory it could work. Practically, I have never seen shallow perched ground water infiltrated to greater depths. If your residence is built directly on a shallow perched ground water table and underlain by a thin confining layer which is underlain by a very permeable layer, THEN it...
  14. geodan

    Test Fill for compressibility characteristics

    Hcubed You stated you wish to "determine compressibility characteristics at a site that is underlain by highly variable fills (including wood waste and sawdust) and soft native ground." Soil of itself is generally anisotropic and nonhomogenous. When you introduce 'highly variable'...
  15. geodan

    GPR as inspection tool

    smwpe now I understand. However, what if your "findings" indicate bad soil, and overall negative results? Is he willing or ready to accept these results? Or is he only willing to pay if you give him "assurance"? Prehaps he is just looking for cheap insurance. If that is...
  16. geodan

    GPR as inspection tool

    smwpe I don't understand the need for GPR. You have been retained for QA/QC construction inspection/testing of; -subgrade compaction -percent organics -placement of reinforcing steel These inspections/tests can be done using standard methods. Where do you need to use GPR?
  17. geodan

    Soils Report

    Jackelmatador- I was being a bit facetious. I'm not litrally recommending running away, especially if the property is resonably priced. However that said, tension cracks (visible? length/width?) and a property on a hill... Just also be aware that a detailed soils report likely will outline...
  18. geodan

    Soils Report

    Oh my, RUN AWAY! tension cracks? BURRIED TOPSOIL? Whoa, seriously look into this purchase a bit deeper. How much topsoil burried? To what depth? Volume? Tension cracks? Is the property sloped or located at the top of a slope? Is there structural fill on the property? Topsoil is a problem...

Part and Inventory Search

Back
Top