Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. Mohamed Mowafy

    Design tools

    Thanks it helps
  2. Mohamed Mowafy

    Design tools

    Not FE tool; just a quick tool based on theoretical mathematical equations; used to calculate properties, capacity of laminate
  3. Mohamed Mowafy

    Design tools

    Dears, Does someone know any website providing a free tool for designing/verifying the composite material not seeking to simulate whole buildings ; just quick tools for daily laminate verifications.
  4. Mohamed Mowafy

    Composite tray laminate check

    Hi everyone, I was reviewing a calculation report for a structure made of composite material and came across a check called "Composite Tray Laminate." It appears to be used for assessing joint areas against a failure mode associated with composite tray laminates. I’m not familiar with this...
  5. Mohamed Mowafy

    Connection between MSC Apex and SAP2000

    Hi, can i import meshing from Apex to sap2000 ?
  6. Mohamed Mowafy

    MSC Patran Subcases issue

    Thanks, i deleted all the results before running and it's working.
  7. Mohamed Mowafy

    MSC Patran Subcases issue

    Hello, I have a patran model and have assigned the subcases and sent them to Nastern for analysis. I have imported the results from the.XDB file in Partan for review, and I found a new subcase has been generated with the same ID, but the software adds SC before it. For example, I defined a...
  8. Mohamed Mowafy

    Discussion: Notional loads have no major effect on steel design ratio.

    As we know, if we want to adopt the direct analysis method in steel design, there are some steps to fulfill the code requirement. 1: reducing stiffness by 0.8 2: Assign the slenderness factors K major and K minor for all members by 1.00. 3: applying the notional load as a percentage of gravity...
  9. Mohamed Mowafy

    Hooped Truss

    interesting truss
  10. Mohamed Mowafy

    Calculate lifting steel

    there's a software called (MecaLug)that you can find it easily in LAVTEAM website, i usually use it in designing lifting lug as case you proposed.
  11. Mohamed Mowafy

    Corrosion? happening on galvanized connector plate

    Don't worry, just repair it by emery with sand papers and spray it with anti corrosion epoxy.
  12. Mohamed Mowafy

    Cee purlins

    i would recommended to you a software named (CFS) cold formed section , i use it everyday in my cold formed design , its easy to use and report is very good and satisfied .
  13. Mohamed Mowafy

    Abbreviations I.F. & O.F. for reinforcement

    yes i confirm your that (I.F.) and (O.F.) is inner face & outer face

Part and Inventory Search

Back
Top