Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. gottemewrong

    Shear and Torsion not perform messages

    hello pals, I have some problem with my 4 level space frame which I design with plates to get away slab stiffness attach to frames after meshing it sub divide my whole length beam into sub-beams 1 meter in length as I run the Analysis I have no errors and warning messages but got this...
  2. gottemewrong

    Staad Pro messages

    Thanks to reply Pals Will I have the parameter before eface and add sface later skeptic that it is the root cause, I assigned 0.8m before if I recall it right because my beam depth is 800 mm, got the messages mentioned change it to 1 m, got the same messages remove the parameter...
  3. gottemewrong

    Staad Pro messages

    Hello Pal Need some insights with this messages, but I have to clarify first my input I have space frame that I use plate load instead of floor load to get away with stiffness of slab connected to frame, what happen my whole length beams were divided into sub-beam 1 meter in length, as soon...
  4. gottemewrong

    Moments Sign Convention for P-Delta Column Desinged

    In designing col for sway frame, P-Delta effects and Moment magnification is applied when its suffice with limiting value. Now the code says that the smaller value moments should be negative in column in question but positive when single curvature. Lets move back in analysis of frames by moment...
  5. gottemewrong

    Base Plate on Steel Beam (not Concrete)

    I would add, you have to make sure that your anchorage can withstand the moments transfer from shearing and pull-out...
  6. gottemewrong

    Thin Flooring topping

    hi pal's: Im worry about my mortar toppings Which is 5mm is the thinner and about 15 mm the thicker, I have to overlay it in the old slab, I have to do it due to limited time. The thing is, it is prepared so the "thin pressed narra flooring" will be install by which will be hammered to stick...
  7. gottemewrong

    Drilling hole on structural slab

    thanks to all!! Well, I will start from your ideas and suggestion...In a week I think I will start my task.. again thanks a lot. More power. Regards; fratrowie
  8. gottemewrong

    Drilling hole on structural slab

    Hello Palz Im trying to have a new partition wall on a condo unit on the fifth floor, I have to drill on the floor slab 12 mm diameter and 4" depht apaced at 60 cm apart for my vertical reinforcement for CHB partition.. the structure is 28 storey high, no details for the structural design...
  9. gottemewrong

    Guides?

    hello pals: Im working structural analysis by hand for a time but comes in my mind thats all of my appoached were all approximation, Im looking for a detailed and much exact analysis for the two way slab, this elastic difference and elastic deformation were good? what can you say? hope that...

Part and Inventory Search

Back
Top