Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Studs & Nut Standards for Stripping Nut
We are using a high speed driver, similar to a Dremel tool, but larger. Its mounted in a specific manner that it stays upright with the die facing down, so its very likely that the galling is happening due to this, upon looking back, it seems that these issues started becoming more common after...- SalCas
- Post #3
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Studs & Nut Standards for Stripping Nut
Good day everyone, I would like some support regarding standards between bolts and nuts to see if I can fix an issue I'm having at the moment. The issue is that on a plastic base with 4 studs "perpendicular" to the base keep getting its nuts either stuck or the nuts end up breaking the stud...- SalCas
- Thread
- Replies: 3
- Forum: Drafting Standards, GD&T & Tolerance Analysis
