Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. Mernok1

    Weight Distribution Over Six Points

    Well. I messaged in my previous comment that there is a problem with it as you pointed out. Otherwise, I wouldn't have shared it on this forum.
  2. Mernok1

    Weight Distribution Over Six Points

    Thank you for response guys. The requirements for this project has changed (as always) since my first message and I ended up generating and FE model in ANSYS. This model is a bit more representative to the reality. You will find several load cases if you open the file. My reaction forces are...
  3. Mernok1

    Weight Distribution Over Six Points

    We are assuming that the plate is a rigid structure in this case.
  4. Mernok1

    Weight Distribution Over Six Points

    Hi Everyone, I have a structure supported by six legs that are bolted to the floor. The top view of this setup is shown below. The center of gravity of this structure is marked with a green X, the fixed support legs are shown with red points. I would like to work out the force exerted on the...
  5. Mernok1

    Surfacing Indentation Direction

    Hi Everyone, I have created a surface between four curves using Through Curve Mesh. As you can see on the images the cross curves are different and the transition creates an indentation starting from the cross curve on the left. I would like to vary the direction of this indentation to match...

Part and Inventory Search

Back
Top