Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. mechabaqususer

    Abaqus Standard, solid model, zero VOL. FLUX warning

    Is it possible that this warning is connected with fact, that there are regions with different elements used (hex, wedge)? Thank's for answers.
  2. mechabaqususer

    Abaqus Standard, solid model, zero VOL. FLUX warning

    Hello, I have a solid model - a half of cylinder. Inner surface of cylinder is loaded with constant pressure (general static analysis). Material is defined as hyperelastic. When i run the simulation, next warning appears: There is zero VOL. FLUX everywhere in the model based on the default...
  3. mechabaqususer

    Error in CFD model

    Hello, Does anybody have any experience with the following error: Quadrature Errors in Pressure Poisson Equation - Element(s) severely distorted. Possible diagnostics are: (A) Check the quality of the elements in the mesh to see if they confirm to the element type specified. It is possible...
  4. mechabaqususer

    how to apply torque on shaft in abaqus?

    Maybe there is another option: apply equivalent rotation (UR)
  5. mechabaqususer

    Abaqus - mesh

    I've used partitions: i defined cutting planes, partition face-sketch (offset curves for narrowing part - i create outer and inner (core) section)...i've tried to use swept/structured technique, as mentioned before. But i still have problems with some areas - where the 'curvature' is large...
  6. mechabaqususer

    Abaqus - mesh

    Hm...about meshing the core using a swept mesh and structured on the outside - my opinion is, that this is one possible option. For example, such technique is also used in Abaqus Documentation, Getting Started with Abaqus: Interactive Edition, Flow through bent tube. This is in version 6.12. I...
  7. mechabaqususer

    Abaqus - mesh

    Anyone?
  8. mechabaqususer

    Abaqus - mesh

    Hello guys, I have a question about meshing cylinder parts in Abaqus. I know, that for these problems, commonly use practise is next: use of partitions, core is meshed with sweep meshing technique and outside cells with structured technique (seeds are concentrated near the wall). But this is...

Part and Inventory Search

Back
Top