Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. iwalters

    Pile of UI issues with ST4

    I've also noticed that when you enter a value into a dimension handle to edit that dimension, that the box disappears. Between this and the text not facing the viewer it's as though they're trying to purposely hinder non-synchronous use.
  2. iwalters

    Pile of UI issues with ST4

    Ok I solved one problem. You can disable the display of the move/orientation wheel under the select ribbon in the home tab.
  3. iwalters

    Pile of UI issues with ST4

    I've searched and found others with similar issues. I'm coming from V20, and ST2. I don't use synchronous. This is my first time playing with ST4 and I've mostly managed to get the UI back to an actual usable setup but there are a few sticking issues. 1. Font text in sketches is messed up. The...
  4. iwalters

    Dynamic Edit Visual Dimensions

    I have the exact same problem. Compounding on top of it is that all of the dimensions are aligned with the sketch plane rather than being easily visable (square to me.)
  5. iwalters

    Two monitors better then one?

    I guess I'm strange? I just use Alt-tab a lot. One big monitor, please.
  6. iwalters

    Helical Protrusion file size

    Ok I just remade the spring and it's 1.15mb. My computer must've been angry yesterday.
  7. iwalters

    Helical Protrusion file size

    KENAT; I wouldn't mind using a representation if I hadn't previously been able to use an actual spring model. donyoung; Thank you. Now I have to figure out what I'm messing up :)
  8. iwalters

    Helical Protrusion file size

    I've recently changed employers and am now using SE V20 (which I had used in the past) after using SE ST for about 1.5 years. I'm having a bit of a problem. I can't be sure, but I think when I was at my former employer and was still on V19 and V20 I had made helical protrusions, added...
  9. iwalters

    Sweeping solids

    I've done that too but it falls short (if using crosssection) in not representing the stopping point at the bottom of the helix. (the bottom face of the cutter) This outcome should be identical to a parallel helical cutout in that respect, no? In the past I've been able to get around this (sort...
  10. iwalters

    Sweeping solids

    First time poster, long time reader. I've been struggling with this ability in solid edge since I started working with it. Essentially I can't get what I want with either the helix commands or using surfaces. What I'm looking to achieve is a surface (cutout) that would represent a helical...

Part and Inventory Search

Back
Top