Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. ShaunJ85

    air as an assist gas

    I have a customer who uses only air to cut all materials upto 10mm thick. compressor is 16bar, dedicated for only laser cutting. extreme filtration to make it as clean as nitrogen and moisture sensors that shut down the laser source if there is any moisture detected inside the air. This is on...
  2. ShaunJ85

    Facit N1050 NC-Feeder System Disk

    HI, Customer has purchased an old Fanuc based laser with a Facit N1050 NC-Feeded and the message appears on the screen "Load System Disk". Does anyone have a copy of the system disk and instructions on how to load it. I know it is a long shot but hoping someone can assist.
  3. ShaunJ85

    Rumbling

    Have seen them used a lot to round the edges of parts to make painting or plating easier. They will not remove burr edges simply make it not so sharp but will still be there. Is a cheap alternative to something like a lismac or webber edge rounding system. Stainless steel parts still get the...
  4. ShaunJ85

    TRUMPF 3030 Cut Quality

    Have you considered programming so that it does all the slots first then comes back and does all external contours? Are you pre-piercing the slots?

Part and Inventory Search

Back
Top