Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
dimension for reducing tee - radius between run & branch
Thanks for the ideas. I had considered measuring a tee out of our store room. If I can use a r/d of at least 0.02 for a 3"x1½" reducing tee instead of assuming a square edge, my RV inlet piping pressure drop calc will drop from 4.6% of set pressure to 2.7% (which satisfies the <3% guideline)...- CACINAL
- Post #4
- Forum: ANSI (standards) Code Issues
-
dimension for reducing tee - radius between run & branch
Does anybody have a cut sheet for stainless steel 304, butt welded reducing tees? I need the radius for the transition from the run to the branch in a 3" x 1½" SCH 10S tee (MSS SP-43). If I can show that there is actually a radius, then I can reduce the pipe entrance flow loss in my pressure...- CACINAL
- Thread
- Replies: 3
- Forum: ANSI (standards) Code Issues
