Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Abaqus - Microforming Process
Thank you both. I'm a beginner in submodelling. So I would like to share some settings that I'm using in order to see your opinion. In the Global Model (the 1/4 part of the blank showed in the previous image) there is a boundary condition (BC) related to the vertical displacement (axis y) of...- BMBr
- Post #8
- Forum: DASSAULT: ABAQUS FEA Solver
-
Abaqus - Microforming Process
Is it possible to use Submodels to analyze some specific regions in contact problems like that? I'm trying to make a submodel including only the triangle geometry in order to check stress concentration with high accuracy using a fine mesh. The image below shows the stress distribution for the...- BMBr
- Post #5
- Forum: DASSAULT: ABAQUS FEA Solver
-
Abaqus - Microforming Process
Tks, FEA way. Naturally, refining the mesh will help, but I don’t think it is only that. I generated a simpler model to analyze the mesh faster, and when I double the number of elements the changes are not significant in the appearance of the coin. The figures below show the simpler model with...- BMBr
- Post #3
- Forum: DASSAULT: ABAQUS FEA Solver
-
Abaqus - Microforming Process
Hi everyone, I'm trying to simulate a coining process with microgeometry with 0.2mm in the width relief, and I noticed some poor aspect in the final form of the coin. The Figure 1 shows a quarter of the coin and a bad appearance in the contour of the relief with bright spots. The figure 2...- BMBr
- Thread
- Replies: 8
- Forum: DASSAULT: ABAQUS FEA Solver
