Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: wsjoe
  • Order by date
  1. wsjoe

    Cosmos Floworks

    Hi, Is there way to try a trial version of Cosmos Floworks? It's awefully expensive to buy a $8000 or so software? It's really tempting to pay $75 for a pirate version but don't know what to do.
  2. wsjoe

    Fuel flow/rate sensor

    Hello, I am planning on doing some dyno test and would like to have fuel flow or rate sensor. Who sells an inexpensive sensor that's adequate for this kind of job? wsjoe
  3. wsjoe

    Car exhaust pressure and gas flow measurement?

    Thank you andyv8 for your recommendation. Which pressure transmitter have you used? I want to collect data and pick them up from a computer. I guess I can use Labview for data acquisition, but this is kind of expensive. Have you seen cheaper alternatives? Know anything about pitot tubes...
  4. wsjoe

    Car exhaust pressure and gas flow measurement?

    What type of sensor is best suited to measure pressure in the exhaust (muffler) at high temperatures of the exhaust (around 1000F)? I want to measure the pressure at different points of the exhaust and see how they change as engine rpm varies. Which sensor do you recommend? What is the range...
  5. wsjoe

    Spiral cut?

    Thank you for your inputs! How do you sweep CUT? I know the sweep command but don' see the cut part. Sorry guys, I am new to Solidworks. I just ordered Blanchard's book last week. Thanks again.
  6. wsjoe

    Spiral cut?

    I have 2"diameter and 20" long tube drawn fo 0.1" thick. I want to make spiral cuts that's only 2" long, 0.125" wide and through the thickness of the pipe. The spiral pitch is 1 revolution over the 20" long. That means that the spiral cut is 36 degrees. I want to make three of cuts that are...

Part and Inventory Search

Back
Top