Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. InspectionSoftware

    UT (Keypoints) Reference Point

    Thanks for the comments guys! To expand further I am looking for a procedure for UT Reference Points on Straight Pipe/Pipeworks. As stated by (DCASTO) Elbows, lows, etc are obvious UT Points Whilst I appreciate that product, system, and risk are all variables in the selection of UT Points...
  2. InspectionSoftware

    UT (Keypoints) Reference Point

    I am presently writing a procedure for UT Wall Thickness Reference Points. Searching the web and professional sites, I couldn't find any documentation on this subject. I have asked many large Oil/Gas Operators if they had a draft of any sort procedure - None seem to exist!!? OK So I have a...
  3. InspectionSoftware

    ASME VIII Div1

    Hey Guys! Cool Down.... I understand very clearly the implications, experience etc.. of these equations! All I requested was the basic equation. I need to double verify the equation in the software design code. Presently, for example, I have four different equations for Wall Thickness on...
  4. InspectionSoftware

    ASME VIII Div1

    I have ALL the data...I just need the correct Formula
  5. InspectionSoftware

    ASME VIII Div1

    Presently dealing with a Close Drain Vessel. ASME Code Section VIII. Div1 Ed 98 Add 2000 What is the correct formula for Min Wall Thickness?

Part and Inventory Search

Back
Top