Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. matrix02

    How can I boost the signal on my motorcycle's pager alarm?

    Thanks again for your help. The Scorpio uses the 440MHz range. The antenna apears to be a wire coming from within the alarm unit much like a power cord on many electronics devices would be. It's about 13-14" long and directions say to have atleast part of wire exposed(out of bike), so I pushed...
  2. matrix02

    How can I boost the signal on my motorcycle's pager alarm?

    As far as antenae improvements, I don't want to cut up the existing antenae and end up worst off. Is it a big deal to cut and splice antennas on these kind of devices or is it just like electrical wire splicing? Should I replace the existing antenna completely or do I just splice new antenna...
  3. matrix02

    How can I boost the signal on my motorcycle's pager alarm?

    I have a Scorpio alarm which has a good range for a 2 way pager alarm, but I need more. I want to cover about 4 residential blocks. Basically I want to know if my alarm is triggered on my bike or car even if it's parked 4 bloacks away. What will it take to do this? Also what are the...
  4. matrix02

    Bar Stock???

    I would like to thank you all for your prompt responses!! Way to go!! ;) I'm being asked what type of stainless steel I need. I told them 303 cause I don't know what I need. Each 26" 3/4 by 3/8 bar should be able to support 160LBS. It will be used near water in New York city. I assume I...
  5. matrix02

    Bar Stock???

    I need 10' of (3/4")/(3/8") square steel bars. I will cut it into 4 28" bars, which will support 75LBs of pressure each. I will drill a 1/2" axle hole at the tip of each bar. The load will be mounted via 4 1/4" holes for some steel bolts. I have tried for a month to...

Part and Inventory Search

Back
Top