Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Round-ify elements along a curve
Well, the instruction I received on how to do this was wrong and I should have used bent tube element type, so I did that and it's working as it should now! -
Round-ify elements along a curve
Thanks for all the feedback. I've deleted the elements and mesh along each curve and applied a curved beam type. However, the mesh still remains un-continuous as seen in my initial post image despite now being a curved beam type. -
Round-ify elements along a curve
I'm using a beam with a circular tube cross-section. I used a centerline imported as geometry and meshed along the centerline. This is how I've been instructed to do these sorts of analyses. I've seen smooth bends, like the elements have been swept along the curve, using this same method. I was... -
Round-ify elements along a curve
I'm modelling a pipe run and when the element thickness/cross-section is visible, the elements are just portrayed as straight partial tubes oriented along the curve of a bend. How do I apply the curve of the pipe bend (for which I have a centerline imported as geometry) to the elements for... -
Insertion Loss via Substitution Method (ISO 7235) Test Procedure Order
That's the procedure I'm writing, not from the standard. I was asking if there was anything listed in the ISO standard regarding doing which one first. But, during my drive home today, I realized that the standard requires that the generated noise level be 10 dB above ambient, so to have both...- RyanWard
- Post #5
- Forum: Mechanical Acoustics/Vibration engineering
-
Insertion Loss via Substitution Method (ISO 7235) Test Procedure Order
Section 7 covers information to be reported, there is also no 7.2.1.2. I have the revision from 2003, should be the latest version.- RyanWard
- Post #3
- Forum: Mechanical Acoustics/Vibration engineering
-
Insertion Loss via Substitution Method (ISO 7235) Test Procedure Order
Hey, y'all I'm developing a test procedure following ISO 7235 to measure insertion loss of aerospace mufflers. The ISO standard's procedure is quite confusing and doesn't break it down to a step-by-step level, so I'm having a hard time. Right now, I have the substitution duct being tested...- RyanWard
- Thread
- Replies: 4
- Forum: Mechanical Acoustics/Vibration engineering
