Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: jpnj
  • Order by date
  1. jpnj

    Shepard Niles Crane Hoist Net Weight

    Thank you for the quick response. It is a single girder bridge crane w/ underrunning hoist, model 0547 serial 101507. I have obtained a Whiting Crane Handbook that I am referring to, thanks for the suggestion. Also had contacted Shepard Niles with the Model and Serial number, but they say they...
  2. jpnj

    Shepard Niles Crane Hoist Net Weight

    I have a Shepard Niles 10 Ton Crane Hoist at a government plant and need to have an estimated weight of the hoist for an impact analysis. The manufacturer says it does not have the weight recorded. Any ideas where I can get net weight of a 10 Ton Crane Hoist (estimated, since I cannot find...
  3. jpnj

    Shepard Niles Crane Hoist Net Weight

    I have a Shepard Niles 10 Ton Crane Hoist at a government plant and need to have an estimated weight of the hoist for an impact analysis. The manufacturer says it does not have the weight recorded. Any ideas where I can get net weight of a Crane Hoist (estimated, since I cannot find data for...
  4. jpnj

    Min Pressure on Elastomeric Bridge Bearings

    Thank you all for your helpful responses, I received replies to inquiries to the NYS DOT and a representative of AASHTO that also said the requirement is to prevent walking of the bearing. They both said some states are 'backing off' this requirement if the elastomer is vulcanized to the plate...
  5. jpnj

    Min Pressure on Elastomeric Bridge Bearings

    There is a minimum pressure requirement (for steel superstructures) of 200 psi (1.38 MPa) from dead load and superimposed dead load on elastomeric bearings to ensure proper operation of the bearing. In AREMA 2000 Chapter 8, section 18.3.10, it says if you do not meet this 200 psi minimum...

Part and Inventory Search

Back
Top