Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. RichPWade

    Encoders for Coupling Investigation

    So I need to setup a system for measuring a Wankel engines shaft velocity on either side of an elastic coupling in order to investigate issues with them tearing. I want to setup an encoder on both sides of the coupling to measure shaft accelerations on either side in order to characterize the...
  2. RichPWade

    New User Problem- NX 7.5- Concentric Constraints

    I tried re-making the tube part by extruding the section I wanted to mate to the flange and then adding a sweep for the bend. After this I was able to select the edges to get the concentric mate. Not sure why it didn't recognize the edge when the whole tube was swept honestly but I guess it...
  3. RichPWade

    New User Problem- NX 7.5- Concentric Constraints

    Yes, The tube has a straight section with a circular cross section that I want to mate to a circular hole in the center of the flange.
  4. RichPWade

    New User Problem- NX 7.5- Concentric Constraints

    I'm a new user to NX having used Solidworks for my entire career. Only been using NX for about a week now. Currently I'm trying to apply a concentric constraint in an assembly but I cannot select any surfaces on either of the parts. One part is a simple bent tube that I made with a sweep and...

Part and Inventory Search

Back
Top