Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. Brancap

    Excessive camber in crane girder?

    Thank you all for your replies. Camber is up. It was measured with a fishing line and a piece of measuring tape on the middle point. The girder was on the floor laying over supports on the ends, where carriages will be. As LittleWheels asked about what fabrication tolerances standard we were...
  2. Brancap

    Excessive camber in crane girder?

    Thanks for your replay LittleWheels. That point was not specified, just that the crane would be calculated under CMAA standard.
  3. Brancap

    Excessive camber in crane girder?

    Hi guys, I have a problem and would like to know your opinion or experiences. We are constructing a single box girder bridge cranes of about 18m span. According to CMAA, camber should be "equal" (they use that word) to a calculation that, for our case is 16mm. After measuring, we found that...

Part and Inventory Search

Back
Top