Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
Using dimension with plus minus tolerance at intersection of basic dimension.
Thanks everyone for the input. I was also not seeing anything in ASMY Y14.5-2018 that restricts this method. But you did bring up good points on the orientation concern by not having datums. Clarifying that this is a basic gage dimension is also a good idea, our inspectors got thrown off by...- Vladdo
- Post #7
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Using dimension with plus minus tolerance at intersection of basic dimension.
I have a small feature with an angled wall and want to locate its position. When using the corners of the feature it's difficult to get repeatable measurements due to the small size and variation in the radii. So instead, I have a basic dimension representing the contact point of the mating part...- Vladdo
- Thread
- Replies: 6
- Forum: Drafting Standards, GD&T & Tolerance Analysis
