Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. lazerboy

    Parameters for 1mm galvanized steel, Trumpf TruLaser 2030

    What Amada tracing system, did you reply to the right thread?
  2. lazerboy

    Trumpf 3030

    This might or might not be the problem. This happened to our 2030 machine. Take the cutting head off, then unscrew the locking mechanism completely and check that the spring inside is not damaged or mangled. If it is, it will prevent the head from sitting flush/straight.
  3. lazerboy

    Parameters for 1mm galvanized steel, Trumpf TruLaser 2030

    Haven't got around to trying with air yet, but wouldn't that speed the process of oxidation along the cut edge resulting in rust down the track? Currently using the following parameters. Cut is reasonable but I am sure it could be faster and cleaner 5" lense 1.2mm nozzle -0.5mm focus 1500W...
  4. lazerboy

    Parameters for 1mm galvanized steel, Trumpf TruLaser 2030

    Hi, I am having trouble getting a good cut on 1mm galvanized steel on a Trumpf TruLaser 2030. I need help with parameters. I get fine burr on the bottom of the cut edge and cannot get a fine cut without slowing it right down. Trying to cut with nitrogen, 5" lens. Also tried 7" lens. Played with...
  5. lazerboy

    Lug/burr inside cut circles - Trumpf TruLaser 2030

    Hi everyone. My first post here. I have been operating the Trumpf TruLaser 2030 for about 6 months now, so I am quite new to laser cutting. When cutting circles (any material), a small lug/burr is left which makes it hard to fit in the required pin/bolt etc. There is an option in TruTops which...

Part and Inventory Search

Back
Top