JNieman, you must not have seen the section at the bottom of the image where it states the profile tolerance and says "Untoleranced dimensions are basic".
The only default tolerance information on the drawing is what is shown at the bottom of the image.
I did not include the entire drawing...
The holes are counterbored. I figured measuring from the datums was correct, one of our machinists disagreed with me on it so I figured I'd get a second opinion.
Thanks
There is another view which gives enough information to determine the location of the holes relative to the datums. You're saying that I should inspect this using the 0.1 Profile tolerance from the datums, not the edges they are dimensioned from? There are no tolerances for the holes beyond the...
I'm inspecting a part which is toleranced in a way I have not encountered before. I believe the method used is incorrect, but I'd like a second opinion.
As you can see the untoleranced dimensions are basic, but they are not dimensioned from the datums called out in the profile tolerance FCF...
