Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. evosmudge

    Torx driver tip

    Thank you takedownca. I have never tried that approach, but will use that technique from now on.
  2. evosmudge

    Torx driver tip

    - CorBlimeyLimey I tried both the swept-cut and revolved-cut but did not get the results I wanted. Thank you for the suggestion. - BiPolarMoment This is to be modeled as a traditional torx driver but with the size of the bit, the paralleled tips are required to make a stronger edge. Also...
  3. evosmudge

    Torx driver tip

    Does anyone know how to extrude the tips of a torx driver? The tip end is narrow and tapers out to the diameter of the rod. The "tips/blades" of the stars are to remain parallel until it reaches the final rod diameter while following the angle of the taper. I've tried extruding the arc at an...

Part and Inventory Search

Back
Top Bottom