Aspentech does handle condensation on air with extended surface, unless you are talking of non round tubes.
Finding errors always happen in software, the real question is did aspentech fixed them after you told them...
Hi
I am not sure I agree with Pastil. I dont see any advantage to have 2 software providers when you can get the 2 from one vendor.
AspenTech offers both thermo and mechanical tools. However I do agree with him when it says it can be expensive. To be sure, you can contact the companies and...
The latest version of HTFS now call Aspen SHell & Tube exchanger does support single and 2 phases calculation for Rod Baffle.
As Unclesyd said, if you have any question do not hesitate to contact Aspentech support, they should have your answer.
it seems that you didnt define an inlet stream, as such there is no flow going through your process.
you need to have a stream get in the first block with the definition of the stream composition and process condition.
Hope it helps
I disagree if you keep the same number of passes and increases the number of plates (channels) the pressure drop will decrease and the local heat transfer will decrease. However the overall surface will increase and the overall heat transfer is likely to increase.
the pressure drop is the sum...
Hi
the result means that the exchanger doesnt have enough surface for the specified fouling.
The service results are based on using the "required" surface with the fouled condition.
The dirty is using the real surface of the exchanger with the fouled condition
the clean is using the real...
