Search results for query: *

The Capital Harness is the equivalent of the SW Electrical harness, run by Siemens (NX). Thanks for your answer, Chris! :) (y)

UGperson, Thanks a lot for your details. :)

Hi, Is there anybody in this group using Catia Electrical Harness design, and Capital Harness design as well?...... Are they very different? Thanks,

Hi, Is there anybody using SW Electrical Harness design, and Capital Harness design as well?...... Are they very different? Thanks,

Hi, Is there anybody using Catia Electrical Harness design, and Capital Harness design as well?...... Are they very different? Thanks,

Hi, Anybody in this group using (Siemens) Capital Harness?

Thank you, Cowski.

Hi, Briefly, what NX X brings in addition on NX?............ Thanks,

I understand you very well. I had the same reaction....

Mmaulin, Yes, your reply solved the problem. The sketch had and extra curve, overlayed on another. Thanks a lot! (y) :):):) I am laughing of myself: how could I have done such a thing?!!!!!...............

I am getting closer....... There are TWO solids, I have no idea how that has happened. Below is a picture showing the two solids (I gave the different colors, for evidence and place them in "Show" and the other in "Hide"... I do not know why the Extrude (2) has two solids! Creating a...

Yes, it's strange......

Thanks, Cowski. I had the same initial thought before; I double checked, I chosen to subtract.

Hi, This is a very simple operation and never had this problem. I created a tube using extrusion of a sketch circle: The subtract tool doesn't perform. There is just a shadow of the operation, without cutting. Where am I wrong? Thank you!

Toost: Now, I fully agree with you! Thanks!

Great, thanks a lot Cowski! :)(y)

I did use the "command finder " (along with CTRL+1, too) so far. I got it. I was wondering where should be placed & found (for instance) the "Pattern Geometry" tool. (I am assuming that under "Home" tab, don't you think? Thanks a lot!

Hi, How could I locate the location of a tool? In the attached picture, I want to run the pattern geometry: Where could I find it (among the highlighted area), other than clicking on the Ctrl+1 (Customize)?.. Thank you,

Hi Toost, Thanks for your inquire. Yes, I am trying to learn methods to apply on real model.

For some reasons, the associativity on my NX is by default inactive. But is it don't matter; I just wanted to know the fact. Thank you so much!