If I am not mistaken, after you use your derived standard one time the HW will default to that standard. At least mine seems to default to the "last used". But then again maybe I've put to many hours in this week
I've had the same issues. What I did was create a set of "favorites" to use in the hole wizard a needed. You only have to create them once.
Mike Eckstein
Just a thought on multi-sheet drawings and using the SWX revision table. You will not be able to assign different revision levels to different sheets in the same drawing project. SWX rev table references Sht#1. If you have a Rev D on sheet#23 all you can put on sheet#23 is the revsion "symbol" a...
