Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by zofiron
-
Position Tolerance to Three Datums
Thanks for the responses! Just to clear some things up: this is not a design/drawing that my company has created internally. Rather it is a customer-driven drawing that we must adhere to the best we can. Unfortunately we see incorrect GD&T quite often, though I didn't know about the flatness...- zofiron
- Post #6
- Forum: Drafting Standards, GD&T & Tolerance Analysis
-
Position Tolerance to Three Datums
Hello, I apologize in advance for my basic understanding of things, I've only been in my trade for a few years. I've learned enough to know what I need to make good manufacturing decisions, but I feel that I'm a bit lacking in knowledge regarding inspection. Here's the situation: I've got a...- zofiron
- Thread
- Replies: 6
- Forum: Drafting Standards, GD&T & Tolerance Analysis
