Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by ZafirOlegof
-
Special Processes (IRIS)
You have to perform destructive test for the initial production parts and sacrifice first 1 or 2 parts with destructive testing. there is no other way, you need to have cut ups from the parts and evaluate the results. To have a general idea about the requirements you may check NADCAP site, used...- ZafirOlegof
- Post #3
- Forum: Mechanical engineering general discussion
-
O Seal fitting compaatibility?
I try to check SAE J1926 from net, and Ted is right about the shape of the surface, however it will depend on the mating surface of your assembly. I mean if mating surface is a flat surface, this may solve your question. please note that when o-rings are used in such assemblies results usually...- ZafirOlegof
- Post #5
- Forum: Fluid Power engineering
-
New engine bearing wear?
As far as I know wear observed in car engines are due to piston movements in first runs. Bearings should not be damaged, or any loose of material from the bearing should not realized. If particles observed are bigger than the filter that means there is problem in the engine. In that case a...- ZafirOlegof
- Post #22
- Forum: Engine & fuel engineering
