Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by zach.farley

  1. zach.farley

    [MathCAD 15] Importing AISC Shapes Table and Pulling Properties

    It adds parenthesis around any calculation done using those values. IRstuff was correct about the matrix and I found that I could get rid of the parenthesis just by adding [0 to my vlookup formulas. When I first recreated your formulas I left out the subscript 1 (or [1 ) that you had because I...
  2. zach.farley

    [MathCAD 15] Importing AISC Shapes Table and Pulling Properties

    Thanks again. I have one last question. All my values for the properties get returned with parenthesis around them. Is there a way to get rid of this? I notice that it does not happen with yours.
  3. zach.farley

    [MathCAD 15] Importing AISC Shapes Table and Pulling Properties

    Thanks so much for your help. I was able to replicate your reply in my own file. Do you know if there is a way to automate the properties part tho? So that it would give me the properties immediately after defining a member rather than having to repeat each vlookup command?
  4. zach.farley

    [MathCAD 15] Importing AISC Shapes Table and Pulling Properties

    Hi all, I'm a total newbie to MathCAD 15 but I am wondering if anyone could provide some guidance on how to insert an Excel file into MathCAD that would then allow me to define a certain cell in that file and have MathCAD return values from other cells. Basically what I am trying to do is link...
See more

Part and Inventory Search

Back
Top