Recent content by yx2002

Thank you all! I found that Flender has an equivalent one.

Hi, Scooty, macmil and blacksea, Thank you all very much. What would be perfect for me is an equivalent product of SEW FA- gearmotor. No luck so far.

Thank you again. I will take a look and keep you posted.

Thank you very much ScottyUK. I am looking for 5.5KW and about 50-60rpm output, shaft mount gearmotors.

Hi, All, We have chosen SEW- Eurodrive gearmotors and their drivers for a new products. After testing, we noticed there are some limitations of the gearmotors. Now we are looking for an alternate gearmotor with drivers. Any one has any good reputation names? Thank you very much for your help...

Thanks again, folks. We have been tried SEW and Nord. They are not exactely interchangable. I just went to Boston's website. It looks close. I will contact the supplier for more info. Thank you all.

Thank you so much. The product itself is good. We have been using it for more than 10 years. But recently the delivery is too bad.

Hi, Fellows, We want to switch HUB CITY's Gear Reducer "Model 134" to some others. But it has to be cross over, because we don't want to change our mounting positions etc. Any suggection is highly appreciated. Thanks, Carrie

No one could help me?

Hello, We are looking for a small dual-acting hydraulic manual pump (max.200lbs of load) mounted on our boom to replace a Ratched-Action load Jacker. I did a little bit search. The results are far away from our requirements. Any infomation are highly appreciated. Thank you very much. Best...

John, Thank you so much. I checked both. From the Tach. Data, Maleme looks better to us. Carrie

Thank you for your reply. The hose Dia. is 3/4". Thanks.

Hello, Does any one know that where I could find a Safety Excess Flow Check Valve or "Velocity Fuse" for compressed air? Many thanks, Carrie