Recent content by ywioywio

can fluid80 be used to simulate fluid trapped inside a cavity with Pressure(DOF) i want to couple a volume of fluid with a rubber container where the container will be deformed causing pressure rise inside the fluid however, when i experiment with fluid80, there seems to be no DOF for pressure...

thanks for your help i'll try this model

Hi elogesh and hulkhogan, thanks for your advices, guys i think my previous question is rather vague my 3D hollow cylindrical model is completely closed (i.e acts like a container or tank fully filled with liquid) displacements will be apllied to the solid cylinder alone, and the fluid is...

Hi, thanks for your advices, guys i think my previous question is rather vague my 3D hollow cylindrical model is completely closed (i.e acts like a container or tank fully filled with liquid) displacements will be apllied to the solid cylinder alone, and the fluid is initially at...

dear all, i want to simulate the solid-fluid interaction and be able to calculate the hydrostatic pressure of the fluid. my model consists of a closed cylinder completely filled with fluid, and the cylinder will be deformed in a certain way, such that the hydrostatic pressure of the fluid...

my model consist of irregular surfaces, and i want create a colored contour plot of the curvatures(such as mean and gaussian curvatures) on the model after some deformation can i do this using ansys, and how should i go about doing this. thanks

Dear all, i've built a hollow cylinder which is enclosed at the lower end, and meshed it with solid186. The model is fully constrained (ux,uy,uz=0), and i'm trying to apply a rotation of 20 to 30 degrees at the enclosed end. however, when i tried applying the rotation (just 1 degree), enclosed...