Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by yoketech
-
Thin walled tube threading
I have an 6061 aluminum tube (1"OD x 0.058" wall) that requires an end cap on one end and a retaining ring on the other to keep parts inside. The tube is turned down to 25mm OD and anodized for use as a linear shaft. For the past while we've been having the end caps welded in place, then turning...- yoketech
- Thread
- Replies: 5
- Forum: Mechanical engineering general discussion
