Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by Yaojun Han
-
Discerning type of thread without using a gauge
The spacer did not have markings, perhaps due to it being a non-standard part.- Yaojun Han
- Post #6
- Forum: Mechanical engineering general discussion
-
Discerning type of thread without using a gauge
I'm looking for a replacement for a spacer that I only have a sample for. It's a male/female type of spacer, and male end is 4-40 thread. Problem is, the female side can either be 6-40, or M3.5x0.6 thread. Is there a way to tell without using a gauge or felt (I don't have one)? On another...- Yaojun Han
- Thread
- Replies: 6
- Forum: Mechanical engineering general discussion
