Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by yanyanh

  1. yanyanh

    Read out Volume and Mass after Scaling

    Hi I'm working with NX 7.5 and was just scaling an engine block uniformly by a factor of 0.85. After scaling I wasn't able to read out the volumen and mass,because it's just showing me 0.0m^3 all the time. I tried to export it as parasolid but then had the same problem. Do anybody have a...
See more

Part and Inventory Search

Back
Top