Israelkk,
Pulling force mean magnetic force (magnetic field strength) and thats why I used Tesla. sorry for the inconvenience.
I am from poland (Warsaw).
Urself?
Hi,
Yes the pulling force need to be 350 milli Tesla, and the power supply is 12VDC. It will be an open case (round) electromagnet. The optimum voltage setting is 7VDC and Optimum Current setting will be 330mA. Maximum power rating should be 6 Watts. The location of the force should be at one...
Hi,
I am trying to design an electromagnet which will produce 350mT magnetic field, available current is 350mA from 12V supply, Size of the magnet is a big issue for the device so as small as possible ( 30mm wide*25mm high)approximatelly. I m totally new for electromagnets so It would be great...
Hi,
I am trying to design an electromagnet which will produce 350mT magnetic field, the power supply is 12V and current should be not more than 410mA, The size of electromagnet is a big issue for my device, so as small as possible, I never worked on electromagnets before so feeling some...
Hi,
I am trying to design an electromagnet which will produce 350mT magnetic field, the power supply is 12V and current should be not more than 410mA, The size of electromagnet is a big issue for my device, so as small as possible, I never worked on electromagnets before so feeling some...
hi,
it will be great if someone give me a suggestion please;
if there are two op-amp in an IC,e.g MAX4203, can i use one filter(a resistor2.2R & 1uF capacitor) to +5V and another filter for -5V, rather than using two filters for a each op-amp +5V and -5V.
Many Thanks
Aziz
I wish to connect two IMS4831E boards to drive two stepper motors on X and Y-axis with the help of party line command, I am following the instructions as in software and hardware manuals of IMS but both the boards are not communicating with each other and after sending command to one board the...
