Recent content by XtremeBen

That did it! Thanks for all your Help! [2thumbsup]

Thanks a lot for the Code neilc78, We have had a whole lot of sucess with everyone's help. I do have one more problem. Is it possible to have this same macro open the "master" excel file and keep it open while SW updates the design tables, and then close the "master" file? We have had sucess...

You know what, we were able to figure it out. Thank you very much for all your help, this will make things a whole lot easier here. Thanks again! :)

That did it! I hate to keep bothering you but is there anyway to close the part files after they have been updated? Thanks a lot!

That did help, we can get it to run now, but it is not finding all of the parts with design tables. For example when I run it on an assembly with about 60 parts (30 of which have design tables), it only finds 1 to have a design table. I think the problem may exhist in the line where you call...

handleman Thanks for the code! I do have some questions though, as I have try to run the code and I get a few errors. Are you running this as a standalone application, or a macro witin Solidworks? I have tryed to run it as a macro within solidworks and I get a "User defined type not defined"...

Neilc78, We may have similar problems. We build Partition walls that can very in Height and Width. We too are working with large assemblies with many different configuration. What we ended up doing was separating them into separate files for each type of Product, rather then suppressing a...

Hello everyone, Our team here at HUFCOR has been working with Solidworks Design Tables for the past few months, in an attempt to integrate them into our product design and structure. Right now we are in the middle of a large-scale product consolidation and are converting our entire product...