Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by xrobc

  1. xrobc

    Taper

    John If I have read what you have done corrctly then you have: Drawn the flatened tapered spout in Sketch007 where the length of the flat is measuerment 27. You then used this to calculate the end diameter (2*measurement 27) place on the datum plane (24) so with the start and end diameters...
  2. xrobc

    Taper

    Hudson What I am trying to effectively do is extrude Sketch_006 (the circle) along sketch_005 with a 3 degree taper angle (as per the attached PDF). I have managed to produce it in AutoCAD by using the Extrude command and extruding along a path and because its a extrude I can apply the taper...
  3. xrobc

    Taper

    Correct on both counts The curved feature and NX5.
  4. xrobc

    Taper

    Please could someone offer me some help on tapering a face/edge. I am trying to put a 3 degree taper along the length of the revolved feature of the attached model, but no matter what I try I cannot do it. Please can someone help! Thanks
See more

Part and Inventory Search

Back
Top