Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Xevuhtess7

  1. Xevuhtess7

    Drafting: Dimension to curve

    Ah, yes! I didn't try that one because I thought it referred to tangent line intersection points. Thanks very much cowski!
  2. Xevuhtess7

    Drafting: Dimension to curve

    There is no "point on curve" snap when the dimension tool is active
  3. Xevuhtess7

    Drafting: Dimension to curve

    Hey all, I am having a frustratingly simple problem but can't find a solution via online search and help docs for the life of me. In drafting mode, I am trying to dimension the overall length of my part (which has a curved end). It keeps dimensioning off the centerpoint of the curved edge, no...
  4. Xevuhtess7

    NX: Surface-to-surface contact unrealistic results

    Blas, That makes complete sense. Thanks for the tip! My model runs as expected now.
  5. Xevuhtess7

    NX: Surface-to-surface contact unrealistic results

    Hello, first post here after many times finding solutions to my problems here. My model is simple: a pin (flanged on both ends) inside a sleeve. The outer surface of the sleeve is fixed, and the pin's flanges are surface-to-surface glued to the top and bottom of the sleeve. I have a...
See more

Part and Inventory Search

Back
Top