Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by wwenzli

  1. wwenzli

    Can symmetry be implied without GD&T?

    I have a part with two holes located symmetrically about the part center line. A basic dimension defines the spacing between the two holes. The symmetry tolerance is 10 mils about the center line, RFS. Here's the question: Is the distance between the holes an exact number, or does it vary? Does...
See more

Part and Inventory Search

Back
Top Bottom