Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by wuhenye
-
Tapped Hole for Lifting Eyebolt - Edge Distance
You should refer to the standard ASME ...,then caculate the distribution of weight of your equipment, to complish your design, such as max lifting load, tensile strenth of lifting bolt and threading,and local stress concentration...- wuhenye
- Post #7
- Forum: Mechanical engineering general discussion
