Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Recent content by wn_007
-
Omada Laser crashing on M104
I will get a pic posted, should be running the laser tomorrow morning. Thanks again.- wn_007
- Post #8
- Forum: Laser engineering
-
Omada Laser crashing on M104
This machine does not have edge detection. Also, the thickness of material does not appear to work properly. In other words it is set to zero and the head has been adjusted to compensate manually. Keep in mind I am researching this on my own by interpreting what our engineer / operator is...- wn_007
- Post #5
- Forum: Laser engineering
-
Omada Laser crashing on M104
This is for an Amada LC1212-Alpha II. I noticed that the title references an Omada laser, sorry.- wn_007
- Post #2
- Forum: Laser engineering
-
Omada Laser crashing on M104
thread380-378667 I am new to this forum. I have read a similar thread regarding the issue that I have referenced. Basically on our Omada Laser it crashes the head on the M104 command. It goes to 0.00 no matter what I have tried including M104 Z.5. I have looked at the cut conditions settings...- wn_007
- Thread
- Replies: 8
- Forum: Laser engineering
