I wish there were a lot more women in Engineering...The ones' I have run it to were very good. Highly organized. I always have great respect for a female engineer knowing they juggle mother role and engineer role.
Take the first Offer. Start working. If the other offer shows up and you decide that it is better, politely inform the first company you decided to work at company #2. Never look back.
Although $12/hour would not support a person's living expenses, you are a student after all. If you are happy and learning a lot, stick it out until you graduate, if you can. If a significant offer doesn't surface from that company after graduation, then they knew you would be moving on anyway...
Is it just me or does the original post claim Swedens' population to be 2 million? The CIA world factbook estimates the population to be around 9 million. <shrug> Minor point in terms of the message the writer is trying too convey.
The writer paints a pretty picture, with a nice "feel good"...
Thanks Casseopeia,
For a brief moment I was actually beginning to believe the US system was above the rest of the worlds' in terms of logical debating and weighing of actual facts, etc. At least in a foreign country you can bribe the "Law" cheaply and they go away and leave you alone.
The fact...
Mr. Craine,
"Another thought just occurred to me, what if I put plates on the face of the columns perpendicular to the direction of the force and throughbolt enough threaded rods to replace the needed ties? What do you think? "
Your idea of dropping down in front of the pedestal and attaching...
Regardless of allowable tolerances, the Contractor is using a technicality to wiggle out of shoddy workmanship. Unless you absolutely are getting a great deal or some other reason for buying, I would stipulate the floor must be leveled (if you want to put down carpet). Get it in writing!
Or get...
I found a reference to this in the APA literature called "Introduction to Lateral Design" which states that "A continuous ridge vent can be used with an "Unblocked Diaphragm". An unblocked diaphragm has no requirement for blocking between unsupported edges of adjacent panels. It also states you...
<quote>Is there any particular reason why you expect to be paid ten, twenty or one hundred times the Indian engineer's pay, if you can only provide the same standard of work?</quote>
This doesn't make sense to me. I think of an invisible line that surrounds the United States. People working on...
Errr, I am embarassed to say I am going backwards technologically.
One of my Mantras is "The Tool should fit my style, I should not be forced to fit the Tools' style". I find this especially true of PDA's and laptops.
This means that I have tried PDA phones, plain PDA, day timer, yellow pads...
I am not sure what the correct forum is for this question, so here goes.
What is everyone's perception of project outsourcing. For instance, I know of a major engineering company who uses overseas personnel to do the work, quite possibly without supervision of an ABET educated and qualified PE...
This was comical, I had read 2 articles today about BIMs and REVIT and I was just about to pose a question about whether anyone had tried REVIT and Viola! There this thread was...
I was majorly intrigued by the claim, in one of the articles, of Revit structural that it could incorporate RISA 3D...
I have worked for some large companies who did not have any ways to make a clean export from Microstation to Autocad.
If you find something please post it back here, thanks.
