Recent content by windsoreng

cksh, I work in automotve industry too. Its really bad out there, would professional designation help me ? Lot of my buddies say that pursuing designation wouldn't make a difference in automotive.

never mind I figured it out.

*** WARNING *** CP = 2.609 TIME= 09:31:04 For material 1 at temperature 23, the initial slope of the stress-strain curve based on the TB,MELAS table (9500) is less than EX(11000).

are you asking how to insert commands?

you can supress other bodies and do preview mesg

I have modal tutorial if you want, its attachedhttp://files.engineering.com/getfile.aspx?folder=4a012d67-6da1-49e1-a2b1-e0ca4b88360a&file=WB-Mech_120_Ch05_Modal.pdf

I am at work and I am getting this error, any Idea? "joint elements with lag mult option do not satisfy joint constraint conditions" Its still running, will see if it converges Thanks

For ex UTS of material is at 135 MPa, and I apply force of 1200N, accoring to the counters in ANSYS the Max stress is 206 MPa at one spot it means its gona fail there. I need to find a force that would generate stress within UTS of material.

Thank you letter is a must, got me hired

I am modelling a plastic part in ANSYS 12.2 I applied mesh,connections, forces and suports. I solved and got solution I applied a froce of 1200N Max stress was at 206 MPa UTS of material is at 135 MPa I need to find the force (which should be less then 1200N) at which the part will fail...

try using a pinball region

where can I find corrections?

I just bought a PDF copy of : This book is awesome, starts from basic and goes into advanced non linear analysis. Must have for someone in FEA field.

Hey OP It was me. I was just checking you.

@ Debaser: They do it because they don't want employee going to trunk of his car and coming back with M-16 and extra magazines. In our company they don't even let you clean your desk.