the weight is really not an issue and was not of any concerns for our client, the guaranty that it will not affect the structural integrity and safety, this was their main concern and we do understand their point,
Hi,
for cleaning operation we need to drill holes (3” to 4”) on tank roof in order to bolt a cleaning device number of holes vary base on size, our problem is to have engineering document to support out operation and gives documented warranty of the roof integrity after the job is performed, our...
Many thank for your time,
Indeed there is a lot to consider in order to perform standard in-service wall inspection, I went through given links I still have to go through some remaining chapters it was very helpful,
could you please help with equipment selection, any brand you know of that is...
our client is requesting tank wall inspection wile in service / shut down is not permitted / no inside inspection is required / Somme kind of intermediary preventive inspection plans / please i need help in acquiring the right equipment to do wall inspection and any information on applicable...
Hi,
I am installing ultrasonic’s flow meters made by GE, I would like them to be caibrated before installation,
Any help with the calibration procedure please.
Thanks,
Hi,
I need help with procurement of gas turbines control systems, specifically I am looking to purchase a Hawker Sidley (HSDE) Digicon controller series 2, please help me in finding good reliable providers for this product.
Regards,
Hi,
We are a calibration lab and we would like to fabricate a calibration bench for relief valves (20-500 bar) used in oil/gas plant, any one with similar knowledge’s that can help us to choose a compressor for such a type of bench please?
I think it will be better to stick with the 2010 standards / ASME / if your concern is only how to feel the hely-tube,
I suggest to fabricate a hydro test kit dedicated to that specific vessel and use it with a crane lifted full water tank that contain at least 1.5 of the total tube volume of...
the code I think used in such a project is [B&PV Code Sec. VIII, Div##], it's a lab equipment for a project and we are hoping to use other people exprc to find a software that will help us in our design or at least some guidance with materials & dimensions charts.
I am Designing a vacuum graphite furnace, 30inch DIA, I need help with the calculation methods/ relation between (shell thickness<--> furnace Diameter) please,
